HRS Charge Controller Specification

The HRS Regulator was the first Marlec regulator to incorporate electronic Pulse Width Modulation (PWM) technology to regulate battery voltage to prevent overcharge. This generation of voltage regulation saw the end of the need for bulky heat sinks to dissipate excess energy generated by the windcharger and, more importantly for the lifetime of the windcharger, introduced speed limiting to the turbine when the battery is full.

The HRS503 is designed for use with the Rutland 504 and previous Rutland 503 models. HRS913 models were superceded by the HRSi Regulator in January 2008.

Features

The PWM electronic charge regulator tapers charge to the battery by gradually limiting windcharger current to avoid battery overcharge.
- When regulating the Windcharger turbine speed is gradually reduced until finally running at just a slow "idle"
- As fully charged batteries are more likely to occur in high winds this slow mode of operation is safer and reduces wear

A solar panel with a maximum rating up to 100W may be connected in parallel with the windcharger.
- Note that a blocking diode must be fitted to the solar panel to prevent it from drawing current from the windcharger

Built-in blocking diode protects the HRS and Windcharger from other charge sources to the same battery, eg engine charging

The HRS regulator can charge a single bank of batteries in parallel

2 Tri-colour LED’s indicate,

1) approximate level of battery voltage between 11-14V and 2) charging status – either charging, regulating or both charging and regulating

Regulating cut-in voltage 13.8V, Maximum charge voltage 14.4V (+/- 2%)

Simple wired connection via 3 flying leads

Net Weight: 0.12Kg Packed Weight: 0.2Kg

Carton Dimensions:160×110x60mm

Regulator Description:

	HRS503 12V	HRSi 12/24V
Rutland 504 Windcharger	CA-11/45	CA-11/46
Rutland 913 Windcharger	N/A	CA-11/46
Rutland Furlmatic 910-3 Windcharger	N/A	CA-11/46

The HRS Regulator incorporates the latest Pulse Width Modulation (PWM) technology to regulate charge to the battery. Combined Windcharger and solar panel input for single battery bank charging, two tri-colour LED’s indicate charging status and battery voltage.

Technical Features

HRS Diagram

12 Volt.

The PWM electronic charge regulator tapers charge to the battery to limit current and avoid battery overcharge. When regulating the Windcharger speed is reduced.