| ·
The PWM electronic
charge regulator tapers charge to
the battery by gradually limiting
windcharger current to avoid battery
overcharge. When regulating the
Windcharger turbine speed is reduced
finally to an idle and as fully
charged batteries are more likely
to occur in high winds this slow
mode of operation is safer and reduces
wear |
| ·
A solar panel
with a maximum rating up to 100W
may be connected in parallel with
the windcharger. NB a blocking diode
must be fitted to the solar panel
to prevent it from drawing current
from the windcharger |
| ·
Built-in blocking
diode protects the HRS and Windcharger
from other charge sources to the
same battery, eg engine charging |
| ·
The HRS regulator
can charge a single bank of batteries
in parallel |
| ·
2 Tri-colour LED’s indicate, 1)
state of battery voltage and 2)
charging status – charging or regulating |
| ·
Regulating cut-in voltage 13.8V,
final cut-out voltage 14.2V (+/-
2%) |
| ·
Connect via 3 flying leads |
| ·
Net Weight: 0.12Kg Packed Weight:
0.2Kg |
| ·
Carton Dimensions:160x110x60mm |
